Canary MicroMux Guía de usuario descargar pdf

MicroMux

Multiplexer

USER’S GUIDE

Disclaimer: The following document is provided to assist users with the installation, operation

and training in the use of our products. This document and our products are intended to be used

by technically qualified personnel. Contained herein is information that is proprietary to Canary

Systems and may not be reproduced or copied in any form, nor disclosed to outside parties by

any means whether directly or indirectly, without the written consent of Canary Systems. This

document is subject to change without notice and Canary Systems assumes no responsibility for

errors, omissions or misinterpretation. Furthermore Canary Systems makes no warranty as to the

suitability of this information and/or products for any given application or use.

Micromux_usersguide.doc Revision A, 02-10

Canary Systems, Inc.

75 Newport Road, Suite 211

New London, NH 03257 USA

Voice: (603) 526-9800

Fax: (603) 526-9004

e-mail: support@canarysystems.com

web: www.canarysystems.com

1 2 3 4 5 6 7 8 9 10

MicroMux Multiplexer USER’S GUIDE Disclaimer: The following document is provided to assist users with the installation, operation and training

Section 3 – Troubleshooting 10 3.1 Troubleshooting Flowchart If you cannot obtain readings using the MicroMux or the readings are unstable then see

Table of Contents Section 1 Introduction 1.1 Overview...

Section 1 - Introduction 3 1.1 Overview The MicroMux expands the number of instruments that may be read by most all types of 5v/12v dataloggers to 4

Section 2 – MicroMux Operation and Installation 4 2.1 Operation Details The MicroMux is controlled by the Datalogger Controller using 2 digital cont

Section 2 – MicroMux Operation and Installation 5 2.2 Datalogger Connections The MicroMux is connected to the Controller or MultiLogger Mux Terminal

Section 2 – MicroMux Operation and Installation 6 2.5 CR10X Program Example The following example illustrates how to write custom programs for the C

Section 2 – MicroMux Operation and Installation 7 2.6 CR1000 Program Example 'Enable our multiplexer PortSet (1,1) 'Wait 100mSec for multi

Section 2 – MicroMux Operation and Installation 8 'Transmit ATDTnn (where nn = radio address), Receive OK (up to 10 seconds) SerialOut (Com1,&qu

Section 2 – MultiMux Operation and Installation 9 2.8 Enclosure Installation The MicroMux can be attached to any surface with 4 mounting 6-32 screws

Sin comentarios

Canary MicroMux Guía de usuario